3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

More documents

Recommendations

Info

VIII. Mounting The Mandibular Cast Fig. 151 Place the jaw relation records between the wax occlusion rims. Be certain the casts or record bases are not in contact with one another. Casts may be secured in this position by using rigid wire and sticky wax. Fig. 152 The mounted maxillary and the affixed mandibular casts can now be placed on the articulator. The casts and articulator are inverted and Whip Mix MOUNTING STONE is added. Fig. 153 The mounting is complete. Additional jaw relation records can verify its accuracy. Accurate fit of the verification records into the V-shaped indices will denote a precise mounting. IX. Setting the Adjustable Incisal Guide Table After the anterior denture teeth are positioned, the adjustable guide table may be set. Fig. 154 Loosen the thumb screw of the incisal guide table and bring the anterior teeth into edge-to-edge contact. 48
Fig. 155 Adjust the inclination of the guide table until it contacts the incisal pin, then retighten the thumb screw. Fig. 156 Move the teeth into a left lateral relation. Fig. 157 Loosen the thumb screw and raise the right wing of the table until it touches the chisel end of the guide pin. Tighten the thumb screw to secure this position and repeat the same operation for the left wing with the teeth in a right lateral position. X. Obtaining Protrusive Record Fig. 158 The aesthetic try-in appointment affords the clinician the ability to verify tooth setup and obtain a well-indexed protrusive record. The record should be created at an extended protrusive position to allow for bilateral condylar movement. 49
Page 1 and 2: 3000 Series Articulator and Quick M
Page 3 and 4: CONTENTS INTRODUCTION 5 OBTAINING F
Page 5 and 6: INTRODUCTION WHIP MIX Articulators
Page 7 and 8: Fig. 5 Loosen the #8604 Thumb Screw
Page 9 and 10: Fig. 13 Inspect the registration fo
Page 11 and 12: Fig. 20 Tighten the center #8604 Th
Page 13 and 14: V. Obtaining Interocclusal Records
Page 15 and 16: Fig. 34 Remove and examine the cent
Page 17 and 18: Fig. 41 Manipulate the mandible int
Page 20 and 21: DIRECT Mounting THE MAXILLARY Cast
Page 22 and 23: Fig. 53 Note: Set each condylar gui
Page 24 and 25: Fig. 60 Hold the face-bow in one ha
Page 26 and 27: Fig. 68 The #28706 Face-Bow Fork Su
Page 28 and 29: INDIRECT Mounting THE MAXILLARY Cas
Page 30 and 31: I. Preparing The Face-Bow And Artic
Page 32 and 33: III. Mounting The Maxillary Cast Fi
Page 34 and 35: Fig. 97 Place the articulator upsid
Page 36 and 37: Setting The Condylar Guidance Of Th
Page 38 and 39: Fig. 112 Tighten the #2432 Clamp Kn
Page 40 and 41: SeTTING THE CONDYLAR GUIDANCE OF TH
Page 42 and 43: Fig. 127 To prevent possible wearin
Page 44 and 45: III. Preparing Face-Bow Armamentari
Page 46 and 47: VI. Preparing The Articulator For M
Page 50 and 51: Fig. 159 Set condylar inclinations
Page 52 and 53: Interchangeability With The Model 3
Page 54 and 55: Maintenance The Whip Mix Model 3040
Page 56 and 57: Model 3140 Articulator # PART# QTY.
Page 58 and 59: model 9600 face-bow For Direct Moun
Page 60 and 61: MODELS 9275/ 9285/9295 FACE-BOWS FO
Page 62 and 63: NOTES _____________________________
Page 64: For additional information, contact

3000 Series Articulator and Quick Mount Face-Bow ... - Whip Mix

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?