Instruction Manual

Dynoware Type 2825A1-2
Tool Diameter
Tool View
Resultant Window
Enter the tool diameter for the appropriate tool under test.
All distances are entered in millimeters, "mm".
This window shows a drawing defining the coordinate
system, and tool measurement layout for the selected
dynamometer.
The resultant window shows channel allocation for
acquired and calculated channels. This should be used as a
guide when configuring graphs.
6.2.1.8 Configurations Using Rotating Cutting Dyno 5237 (High Speed RCD)
Selecting RCD 5237 in the amplifier selection (see section
6.2.1.3 above) will enable the RCD 5237 tab, and the RS-
232C Setup tab.
6.2.1.8.1 RCD 5237
To configure the 5237 high speed rotating cutting
dynamometer, configure the following:
Channel Channel number. Channels range from 1 to 2.
Label
Measuring Range
Unit
Sensitivities
Range Selection
Operate
Reset
Send Parameters
Reset/Operate
Assign labels for each channel. These labels appear in
graphs and reports.
The measuring range is automatically assigned based on
the Scale and Sensitivity settings. Measuring Range [M.U.]
= Full Scale Output [mV] divided by Sensitivity [mV/M.U.];
(M.U. = Mechanical Unit)
Assign units to each channel. These labels appear in graphs
and reports.
Range I, Range II and Range III – enter the sensitivity of a
sensor in [mV/M.U.] for each of the calibrated ranges.
Select the desired measurement range from the pull-down
choice box.
Transmit the command to place the amplifier into the
operate mode.
Transmit the command to place the amplifier into reset
mode.
Transmit the command to set the appropriate per channel
configuration for the Range settings.
Enable the automatic control (via RS-232C interface) of the
Operate/Reset commands during a typical acquisition
cycle. Amplifier will be automatically set to operate at the
start of a cycle, and will return to reset after the acquisition
has completed for any given cycle. In some cases, this
automatic control of Reset/Operate is not desired and the
selection box should remain unchecked.
Page 38
002-195Ae-06.02 (B19.2825Ae)