Compact / CANopen /HMI Controller / XBT GC ... - Schneider Electric
Compact / CANopen /HMI Controller / XBT GC ... - Schneider Electric
Compact / CANopen /HMI Controller / XBT GC ... - Schneider Electric
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TeSysU<br />
Introduction<br />
This chapter presents the TeSysU motor components used in this system. They can be<br />
adapted according to the application (motor output, reversing or non-reversing drive).<br />
Basically, the TeSysU motor control unit comprises of a:<br />
- Power base<br />
- Control unit<br />
- Communication module<br />
- Coil wiring kit<br />
- Optional: reversing block, I s limiter/isolation block and other modules<br />
The following points should be taken into account when selecting components:<br />
A 24 Vdc LU2B xx BL control unit must be used. Make sure it has the BL extension.<br />
There are different versions of the coil wiring kit, which depend on the power base.<br />
LU9B N11C should be used if the power base has one direction of rotation (LU2Bxx)<br />
and LU9M RL should be used if the power base has two directions of rotation<br />
(LU2Bxx).<br />
TeSysU 1<br />
TeSysU<br />
Power base<br />
LU2B12BL<br />
Control unit<br />
LUCA05BL<br />
Communication module for<br />
<strong>CANopen</strong><br />
LULC08 (1)<br />
Coil wiring kit<br />
LU9MRL (2)<br />
2<br />
TeSysU <strong>CANopen</strong><br />
communication module<br />
LULC08<br />
The communication module is<br />
connected to the <strong>CANopen</strong> bus<br />
using cable.<br />
TSXCANCADD1<br />
Optimized_<strong>CANopen</strong>_<strong>XBT</strong><strong>GC</strong>/GT/GK <strong>Schneider</strong> <strong>Electric</strong> 84