RAIDWatch User's Manual

Chapter 8: Channel Configuration
Chapter 8
Channel Configuration
Using RAIDWatch Manager, you can modify the configuration of any
channel on the controller. With RAID controllers like the EonRAID
2510FS, you can set the channel operation mode to host or drive, enable or
disable channel termination, set IDs, set the transfer clock rate for
synchronous communication, and select the transfer width.
Channel configuration settings are available under Physical View in the
RAID View window. This chapter describes the following Channel
Configuration features:
♦ Channel Configuration Window – Section 8.1, page 8-2
♦ User-Configurable Channel Parameters – Section 8.2, page 8-3
• 8.2.1 Channel Mode
• 8.2.2 Termination
• 8.2.3 Default Transfer Clock (in MHz)
• 8.2.4 ID Pool / PID / SID
♦ Setting the Configurations for a Channel - Section 8.3, page 8-6
Channel Configuration Window 8-1