RAIDWatch User's Manual

Chapter 13: NPC Utility Coupled with Mode Three Installation
Step 3. Click Apply or OK to proceed with configuration. Note that the
configuration will be saved to the reserved space on the array and
may cause a short delay.
Step 4. Click Broadcasting List from the tabbed panel above.
Host IP: The IP address a broadcast message will be sent to.
Severity: Select the severity level of events to be sent to the
receiver station.
Computers receiving broadcast messages will be added to the
Host Name list on the right.
Figure 13-8: Broadcast – Receiver-side Settings
Step 5. Click Apply or OK to complete the configuration.
IMPORTANT!
In a massive capacity configuration, it takes a while for the RAID
subsystem to write the NPC configuration profile to every disk member.
DO NOT reset or power down the subsystem before the configuration
can be safely distributed to the array.
Also make sure the subsystem’s Ethernet port and related TCP/IP
settings have been properly configured for the NPC functionality to take
effect.
Configuring the Utility Options 13-7