RAIDWatch User's Manual

Chapter 4: Configuration Client Options
Figure 4-45: Auto Discovery Option
Step 2. Double-click on the current value under IP scan range row to
open the Auto Discovery dialog box. (See Figure 4-46)
Figure 4-46: Auto Discovery Dialog Box
Step 3. Enter a set of IP range that you want the system to detect in the
IP range dialog box.
NOTE:
You may modify an existing IP range by clicking the Modify button or
delete an existing IP range by clicking the Delete button. Click on the
Cancel button to cancel any action you made in the Auto Discovery
dialog box and return to the Auto Discovery main screen.
Step 4. Click the Expand button to add the new IP range into a preset
list.
Step 5. Click Finish button to close this dialog box and return to the
Auto Discovery option main screen.
Step 6. Double-click on the current value under Rescan time row to
modify a time frame in minute that you like the system to scan
the network.
NOTE:
The default rescan time is set to 0 minute that indicates the system will
scan the network only when Configuration Client is starting up. The
Auto Discovery option will be turned off after the first scan.
Step 7. You may turn on and off this option by double click on current
value under Status row (see Figure 4-47) or click on the On/Off
switch beside the pull-down button to enable the option.
Auto Discovery 4-27