User Guide DS-100 Product(range) - Neopost
User Guide DS-100 Product(range) - Neopost
User Guide DS-100 Product(range) - Neopost
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.3 Select & Go<br />
Select & Go is a rapid method of setting up a job without the need for full programming.<br />
You as the user decide which hoppers to load - the machine’s software then automatically<br />
creates a simplified programme. First select the fold type and press . Load the hoppers<br />
and press again. This takes you to the Run screen - press the Start button to calibrate<br />
the machine and begin running. See section 5.4 on the following page for details of<br />
calibrating the machine.<br />
Points to note:<br />
1. You must load each hopper with the default size form set for that hopper (see<br />
Supervisor menu on page 30 for details on setting defaults).<br />
2. For folded documents, the fold type will be the default setting for that hopper.<br />
3. The prime (address) document must be in the hopper furthest from the insert<br />
head, eg. if the lower and middle hoppers are loaded on a tower folder module,<br />
the prime document must be the middle hopper. The prime document must be<br />
loaded address side down and leading for all fold types.<br />
4. There is no OMR or Barcode facility for Select & Go - for this, full programming<br />
by authorised personnel must be used (see page 21).<br />
14