User Guide DS-100 Product(range) - Neopost
User Guide DS-100 Product(range) - Neopost
User Guide DS-100 Product(range) - Neopost
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6 Setting Up The Machine<br />
6.1 Loading the paper hoppers<br />
Insert Feeder<br />
Slacken the locklever<br />
and adjust the<br />
side guides to give<br />
1 - 2mm clearance<br />
across the width of<br />
the inserts. Tighten<br />
the lock lever.<br />
Pull the weighted roller back and load<br />
the inserts, ensuring they are fully down.<br />
Release the weighted roller so that it<br />
‘tips’ the inserts into the pickup roller. An<br />
alternative heavier roller is also available<br />
(part no. C3656A) which can improve<br />
feeding of thick booklets. This must be<br />
fitted by an Authorised Service Engineer.<br />
Note: A single feeder is<br />
shown – if the unit is a tower<br />
or OMR/Barcode feeder, the<br />
method of loading is identical,<br />
but the hopper capacities are<br />
different.<br />
Tower Folder<br />
Slacken the lock- lever<br />
and adjust the side<br />
guides to give 1 - 2mm<br />
clearance across the<br />
width of the forms.<br />
Tighten the lock lever.<br />
Press down on the tray<br />
and load the fanned<br />
stack of forms. Ensure<br />
that the leading edges<br />
are firmly contacting the<br />
chassis bridge at the<br />
lower end of the tray.<br />
Use the indicator lights<br />
on the rear edge to<br />
orientate the paper.<br />
1. Tower folder is shown; feeder<br />
folder is similar except only 1<br />
tray is fitted and there is no<br />
indicator.<br />
2. See the following page for<br />
setting the curled forms stop.<br />
33