User Guide DS-100 Product(range) - Neopost

5.5.3 Advanced settings
Advanced settings allow adjustments to be made to various machine functions. It is specific
only to the job you are in when you make changes, and will be saved with the job,
even when the machine is switched off. Note that this function is password protected.
Warning: Changes made in this function may adversely affect the machine. Use it
only if you know what you are doing!
Collate Pocket Adj.
Adjusts the width of the insert head collate pocket. In steps of
0.1mm.
Fingers Adj.
Adjusts the width of the insert fingers. In steps of 0.1mm.
Start Speed Speed at calibration and first running. Default = 1.
Seal Time
Adjusts time that the filled envelope is held in the closer for
sealing. Note that increasing will slow the machine. In steps of
milliseconds.
Adjust wetter
Adjusts the point at which the wetter beam drops to wet the flap
(+ve = more wetting). In steps of 1mm.
Adjust wetter start Adjustment of the point at which the wetter beam lifts (+ve =
more flap length is wetted). In steps of 1mm.
Adjust env seal stop Adjusts how far into the closer rollers the envelope is fed (+ve =
more infeed). In steps of 1mm.
Adjust env stop pos
Adjusts the envelope stop position at insert (+ve = further
forward). In steps of 1mm.
Insert in env pos.
Adjusts the amount of insertion of the insert pack into the
envelopes (+ve = further in to envelope). In steps of 1mm.
Adjust env rev pos
Adjustment of the amount of envelope foward travel after flap
wetting, before reversing to enter the sealing rollers. +ve =
further forward into the output rollers, towards the exit direction.
19