FELCOM 16

7. MA NTENANCE, TROU LES OOT NG
DCE M Memory remaining in communication unit
ER ulletin oard Error Rate ( )
CN
Check of circuit status with LES, receiving circuit in
antenna unit and RF CON/CPU oard in
communication unit. O appears for figure greater
than 31.
S L v T level check. At transmission, O appears for
figure greater than 123. At reception, O appears for
figure lower than 32.
R AGC L v
Check of the receiving circuit of the antenna unit and
the RF CON/CPU oard in the communication unit.
O appears for figure greater than 60.
REF O F O appears for figure lower than 150.
S L Check of RF CON/CPU oard.
VC O C Oscillator frequency control value.
A P S NG appears for discontinuity or short in antenna
cable. O is shown if the antenna is receiving
electrical power.
T lank
W C
Di i lank
S lank
D lank
Requires data from appropriate sensor.
. R i F
The fuse (12 DC 10A, 24 DC 5A) in the power cable protects the
communications unit from overcurrent and reverse polarity. f the fuse blows, find
out the case before replacing it. f it blows again after replacement, contact your
dealer for advice. e sure to use the correct fuse. Use of a wrong will damage
the equipment and void the warranty.
Use the proper fuse.
CAUTION
Use of a wrong fuse can result in damage
to the equipment.
F
12 DC
Type FG O 125 10A P F
Code No. 000-155-826-10
24 DC
Type FG O-A 125 5A P F
Code No. 000-155-853-10
-