Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECURING FIREPLACE to flo<strong>or</strong> <strong>or</strong> framing<br />
BLDV7 Series <strong>Gas</strong> Fireplace<br />
The fireplace must be secured to the flo<strong>or</strong> and/<strong>or</strong> to framing studs as shown in Figure 5. Use two<br />
(2) wood screws <strong>or</strong> masonry/ concrete screws to secure fireplace to the flo<strong>or</strong>. Use four (4) screws<br />
to attach fireplace to framing. The side nailing flanges are 1/2" <strong>or</strong> 5/8" to accommodate different<br />
wall thickness.<br />
Nailing Flange<br />
Drywall Supp<strong>or</strong>t<br />
Tabs<br />
(Do not use f<strong>or</strong><br />
framing <strong>or</strong> header)<br />
Framing<br />
Screw<br />
Nailing Flange<br />
Figure 5 -<br />
Securing Fireplace to Flo<strong>or</strong><br />
and Framing Studs<br />
Nailing<br />
Flanges<br />
Screws<br />
FP2335<br />
Screw<br />
Finishing Material<br />
FP2335<br />
NOTE: Any remote wiring (i.e. remote control, wall switch, nailing and optional flangesfan) must be done pri<strong>or</strong> to<br />
final finishing to avoid costly reconstruction.<br />
Only noncombustible materials (i.e. brick, tile, slate, steel, <strong>or</strong> other materials with a UL fire rating<br />
of Zero) may be used to cover the black painted face of the appliance. It is permissible to bring<br />
combustible wall board to the top and side edges of the black painted face. A 300°F minimum<br />
adhesive may be used to attach facing materials to the black surface. If joints between the finished<br />
wall and the fireplace surround are sealed, a 300°F minimum sealant material (General Electric<br />
RTV103 <strong>or</strong> equivalent) must be used.<br />
10<br />
74D3000