Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
OPERATING INSTRUCTIONS (Milli-volt)<br />
BLDV7 Series <strong>Gas</strong> Fireplace<br />
approved leak testing method<br />
You may check f<strong>or</strong> gas leaks with the following methods<br />
only:<br />
• Soap and water solution<br />
• An approved leak testing spray<br />
• Electronic sniffer<br />
danger<br />
Check f<strong>or</strong> gas leaks in each of the following locations:<br />
WARNING<br />
• Pipe from the gas supply line connection to the gas valve<br />
• Burner connections<br />
• Pilot<br />
• Each joint <strong>or</strong> connection<br />
Lighting pilot f<strong>or</strong> the first time<br />
Never check f<strong>or</strong> gas leak with open<br />
flame!<br />
Lighting pilot<br />
If using a soap and water<br />
solution to test f<strong>or</strong> leaks,<br />
DO NOT spray solution onto<br />
control body.<br />
NOTE: Remove any excessive pipe<br />
compound from the connections.<br />
Excessive pipe compound can set off<br />
electronic sniffers.<br />
• Field made joints / gas shutoff valve<br />
• Fact<strong>or</strong>y made joints<br />
• All joints on valve and control body<br />
WARNING<br />
The control has an interlock device that does not allow the lighting of the fireplace<br />
up to the moment the safety device of the flame has not interrupted the gas flow.<br />
After that period of time (when the magnet is closed), it is possible to start the<br />
lighting operation.<br />
The gas control knob is designed to be operated by hand. DO NOT use any tools<br />
during this operation. Damaged knobs may result in serious injury.<br />
1. Depress and turn knob counterclockwise<br />
to pilot position.<br />
2. Depress fully and hold pilot gas knob. Depress<br />
piezo igniter as many times as needed to ignite pilot.<br />
Keep knob fully depressed f<strong>or</strong> a few seconds.<br />
Release and check that pilot continues to<br />
burn.<br />
If the pilot does not stay lit, repeat steps 1 and 2.<br />
Pilot Position<br />
PILOT<br />
OFF<br />
ON<br />
PILOT<br />
Continued on next page<br />
30<br />
FP1935<br />
control knob pilot<br />
74D3000