ADAM 4000 Series

Command Set
ADAM-4019 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, baud rate, data
format, checksum status, and/or
integration time for a specified analog
input module
#AAN Read Analog
Input from
Channel N
4-24 ADAM 4000 Series User's Manual
Returns the input value from a
specified channel of analog input
module in the currently configured
data format
#AA Analog Data In Returns the input value from a
specified analog input module in the
currently configured data format
$AA0Ci Single Channel
Span Calibration
$AA1Ci Single Channel
Offset Calibration
$AA2 Configuration
Status
Calibrates a specified channel to
correct for gain errors
Calibrates a specified channel to
correct for offset errors
Returns the configuration parameters
for the specified analog input module
$AA3 CJC Status Returns the value of the CJC sensor
for a specified analog input module
#** Synchronized
Sampling
$AA4 Read
Synchronized
Data
$AA5VV Enable/Disable
Channels for
Multiplexing
$AA6 Read Channel
Status
Orders all analog input modules to
sample their input values and store
them in special registers
Returns the value that was stored in
the specified module’s register after
the #** command
Enable or disable the individual
channels in an analog module
Get the enable/disable status of all
channels in an analog module
$AAAi CJC Setting Configure the CJC setting 4-75
4-44
4-54
4-52
4-65
4-66
4-48
4-63
4-59
4-60
4-55
4-56