ADAM 4000 Series

ADAM-4015 Command Table
Chapter 4
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, baud rate, data format,
checksum status, and/or integration time
for a specified analog input module
#AAN Read Analog Input from
Channel N
Returns the input value from a specified
channel of analog input module in the
currently configured data format
#AA Analog Data In Returns the input value from a specified
analog input module in the currently
configured data format
$AA0Ci Single Channel Span
Calibration
$AA1Ci Single Channel Offset
Calibration
Calibrates a specified channel to correct for
gain errors
Calibrates a specified channel to correct for
offset errors
$AA2 Configuration Status Returns the configuration parameters for
the specified analog input module
#** Synchronized Sampling Orders all analog input modules to sample
their input values and store them in special
registers
$AA4 Read Synchronized Data Returns the value that was stored in the
specified module’s register after the #**
command
$AA5VV Enable/Disable Channels
for Multiplexing
Enable or disable the individual channels in
an analog module
$AA6 Read Channel Status Get the enable/disable status of all channels
in an analog module
$AAB Channel Diagnose Diagnose channel status in over range,
under range, and wire opening
$AA7CiRrr Single Channel Range
Configuration
$AA8Ci Read Single Channel
Range Configuration
Configure the input type and range of the
specified channel in an analog input module
Get the input type and range of the
specified channel in an analog input module
$AAXnnnn Watchdog Timer Setting Set WDT communication cycle 4-71
$AAY Read Watchdog Timer
Setting
Read the setting of WDT communication
cycle
$AAS0 Internal Calibration Internal self-calibration for offset and gain
errors
$AAS1 Reload default calibrating
parameter
Reload factory default calibrating parameter
to overwrite current calibrating parameter
$AAF Read Firmware Version Return the firmware version code from the
specified analog input module
$AAM Read Module Name Return the module name from the specified
analog input module
4-44
4-54
4-52
4-65
4-66
4-58
4-59
4-60
4-55
4-56
4-62
4-67
4-70
4-72
4-73
4-74
4-50
4-51
Chapter 4 Command Set 4-11