SAP2000 SAP2000 Web Tutorial 1

17. Right click on any member to bring up the Steel Stress Check Information dialog box for that
member. This dialog box shows details of the interaction ratio for each design load
combination at each design station along the element.
18 To get additional detail on any item in this dialog box, highlight the item and click the
Details button. A detailed form with design information, similar to that shown in Figure C-
21 will appear. Note you can print this form by clicking the associated File menu and
selecting Print. Click the “X” in the upper right-hand corner of this detailed form to close it.
Note: If this form is too big to fully fit on your screen, you may have to increase your screen
resolution. Typically, it should fit if your resolution is 800 x 600 and you use small fonts
or 1024 x 768 and you use large fonts.
Figure C-21: Detailed Steel Stress Check Information
19. Clicking on the Redesign button will take you to the Element Overwrite Assignments dialog
box discussed in item 13.
20. Click the OK button to close the Steel Stress Check Information dialog box.
SAP2000 Web Tutorial 1 84