Tooling Guide for Aerospace Wiring Systems - Interstate Connecting ...

Electric Hydraulic 3.5 Ton
Crimp Tool for HD36 Dies
A Totally Self-Contained Portable Crimp System for production
The EHCD36 is a fast cycling benchtop
crimp tool designed to be lightweight
and rugged. The versatile features of the
EHCD36 make this a good choice where
production and quality cannot be compromised.
This unit is small in overall size (10.0" H
x 7.1" W x 19.1" L) and weighs approximately
27 pounds, but has ample die
force power to do most jobs. The crimp
cycle time is only two seconds.
Powered by 110VAC with standard
power cord. Other power & cord setups
available.
Compatibility with
Existing Crimp Dies
The EHCD36 is designed to accept
the entire family of D36 dies for crimping
terminals, lugs or any other special applications.
WIRE RANGE: #8 to #0 AWG*
in many power applications, and .750
(19.05mm) in coaxial hexagonal crimping.
This affords total utilization of existing dies
and total interchangeability with HD36
hand tool frame and HDE36B battery
powered hydraulic crimp tool.
Full Cycle Control
Full die closure is assured on every
crimp. The internal cycle control network
will not allow the tool to open until complete
closure is attained. The cycle control
can be overridden with the Emergency
Stop button.
Operator Safety Features
An Emergency Stop button is located
on top of the tool. Depressing this button
releases the hydraulic pressure and allows
the crimp dies to re-open.
A Foot Pedal is Available (P/N EHCFP)
When the foot pedal is plugged to the
unit, it disables the front panel actuator.
Die Selection: The HD36 crimper will
accommodate all crimp dies listed on
page 109. Other applications may be covered
by this tool. Consult DMC for details.
*Wire range will vary depending on wire
and terminal/contact.
© Copyright 2010 Daniels Manufacturing Corp. ALL RIGHTS RESERVED. www.DMCTools.com
PAGE 111