Tooling Guide for Aerospace Wiring Systems - Interstate Connecting ...
Tooling Guide for Aerospace Wiring Systems - Interstate Connecting ...
Tooling Guide for Aerospace Wiring Systems - Interstate Connecting ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Terminal and Splice Crimp <strong>Tooling</strong> Options 8 to 4/0 AWG<br />
Tools and Dies <strong>for</strong> Crimping Terminals and Splices (continued)<br />
8 to 4/0 AWG <strong>Tooling</strong> Options*<br />
HX4 Tool Series Options <strong>for</strong> Y-Dies<br />
HD36 Tool Series Options<br />
HD37<br />
Hand Tool,<br />
p. 108<br />
HX23<br />
Pneumatic Tool, p. 74<br />
HD36<br />
Hand Tool, p. 109<br />
HDE37B<br />
Battery Hydraulic Tool, p. 108<br />
EHCY<br />
Electric/Hydraulic Tool, p. 76<br />
EHCD36<br />
Electric/Hydraulic Tool, p. 111<br />
HDE36B<br />
Battery Hydraulic Tool, p. 110<br />
HD51 Tool Series Options**<br />
Tool Options <strong>for</strong> HD002,<br />
HD485, & HD442 Dies **<br />
HD51<br />
Hand Tool, p. 112<br />
HH80C<br />
Hand Tool, p. 114<br />
XHD51<br />
Pneumatic/Hydraulic Tool, p. 112<br />
TBHD1M<br />
Pneumatic/Hydraulic Tool, p. 114<br />
** Hydraulic pump, hose, and other accessories are shown elsewhere in the catalog.<br />
Wire Stripping <strong>for</strong> Terminals and Splices<br />
Wire strip length and configuration is important to the success of a termination. <strong>Guide</strong>lines <strong>for</strong> particular components being<br />
terminated should be followed carefully. For additional in<strong>for</strong>mation on stripping wire <strong>for</strong> terminals and splices, contact DMC.<br />
Standardization<br />
DMC has maintained a leadership role in military and commercial standards committees such as SAE, WHMA, EIA, UL/NEMA,<br />
and DoD organizations. The following tool selection charts represent the current leading standard components and tools. If questions<br />
or conflicts arise in the use of these charts, please notify DMC (407-855-6161, DMC@DMCTools.com).<br />
© Copyright 2010 Daniels Manufacturing Corp. ALL RIGHTS RESERVED. www.DMCTools.com<br />
PAGE 119