LR-24 Electrofisher - Field Environmental Instruments
LR-24 Electrofisher - Field Environmental Instruments
LR-24 Electrofisher - Field Environmental Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>LR</strong>-<strong>24</strong><br />
BACKPACK ELECTROFISHER<br />
Status Display (Cont.)<br />
Fig. 1.3<br />
Output Waveform<br />
DC Output<br />
(Not pulsed)<br />
Volts= 150V<br />
Fig. 1.4<br />
Output Waveform<br />
Burst of= 3 Pulses<br />
(500 Hz 50%) 30Hz<br />
Volts= 150V<br />
Fig. 1.5<br />
3.) Waveform Screen<br />
A sample waveform screen is shown in Fig. 1.3.<br />
The first line will have "output waveform', unless dual output is<br />
turned on (see System Menu 2 - Dual Output). In this case, the<br />
first line will indicate primary waveform or secondary waveform.<br />
The second line describes the type of pulse. There are three types<br />
of pulses, Standard Pulse, DC and Burst of Pulses.<br />
If Standard Pulse has been selected as the output waveform, the<br />
screen will appear as in Figure 1.3. The third line shows the frequency<br />
and duty cycle of the standard pulse. The fourth line shows<br />
the presently selected output voltage.<br />
If DC has been selected as the output waveform, the screen will<br />
appear as in Figure 1.4. The third line will indicate there is no pulse<br />
and the fourth line shows the presently selected output voltage.<br />
If Burst of Pulses has been selected as the output waveform, the<br />
screen will appear as in Figure 1.5. The second line will indicate<br />
the nmber of pulses selected in the burst. The third line will indicate<br />
in parentheses the frequency and duty cycle of the burst of pulses<br />
and the number on the right indicates the frequency of which the<br />
burst of pulses occur. The fourth line shows the currently selected<br />
output voltage.<br />
Menu<br />
Power<br />
Limit<br />
Pulse<br />
Type<br />
Store<br />
Setup<br />
Volts<br />
Freq.<br />
Recall<br />
Setup<br />
Duty<br />
Cycle<br />
Enter<br />
Volts Key<br />
When the Volts key is pressed, the display shows the output voltage<br />
setting and asks for a new setting. Pressing the arrow keys allows<br />
the user to change the output voltage. Pressing the Enter key enters<br />
the settings and returns to the status screen. The range of this control<br />
is from 50 volts to 990 volts in 5 volt steps. Pressing the Volt key a<br />
second time will abort this function and return to the status screen.<br />
Pressing another function key (other than the arrow keys) will abort<br />
this function and move to the set up display for the key that was<br />
pressed.<br />
Volts Key<br />
6 www.smith-root.com