configuration and options guide - IBM Quicklinks

3581L28TotalStorage Ultrium LVD Tape 2U Autoloader Ultra160 16-bit 7Stand-alone or 2U Rack 35/70 1/1 -3581 63581F28TotalStorage Ultrium Fibre Tape 2U Autoloader 2GB Fibre3581 6 ChannelExternal Tape EnclosuresStand-alone or 2U Rack 35/70 1/1 -45591UX NetBay 1U xSeries Tape Enclosure8 Ultra160 (16-bit) 1U Rack4559HHX Half-High SCSI Tape Enclosure 9 Ultra160 (16-bit) Desktop or Rack Shelf(2.52in tall)- - -0034B0X 2NetBAY Tape Enclosure (Rack Mount) Ultra2 (16-bit) 4U Rack - 1/1 -4559FHX Full-High SCSI Tape Enclosure10 Ultra160 (16-bit) Desktop or Rack Shelf(4.41in tall)- - -3510020 11, 12External Half High SCSI Storage Enclosure Ultra2 (16-bit) Desktop - - -3503B1X 13Full-High SCSI Tape Enclosure Ultra2 (16-bit) Desktop or 3U Rack - - -External Tape Libraries 144560SLX SDLT/LTO Modular Tape Library15 Ultra2 (16-bit) 5U Rack 16/32 (allSDLT); 15/300/0 17 -(all LTO) 161. To determine cable requirements, note the tape drive’s SCSI interface, the appropriate SCSI controller from the system configurator section and thedesired enclosure then refer to Appendix D: Cables - Storage Units - Controllers. For installation of an internal tape drive into a server, see the appropriatesystem section.2. 4U rack-mounted enclosure that supports four full-high or six half-high tape drives. The backplate includes six 0.8mm VHDCI external connectors forattachment of up to six servers. Internal connection of tape drives requires the single-drop terminated LVD SCSI cable that ships with the tape drive, whichalso provides termination for the SCSI bus. A single 320w power supply with a low voltage power cord is standard. An external SCSI storage cable is notprovided. Refer to Appendix D: Cables - Storage - Controllers to select a supported cable.3. Model 3623-2LX has a tape capacity of eight data cartridges providing a media capacity of up to 1.6 TB (3.2TB compressed) data storage per unit. SCSIcontroller and cable are not included. Note tape drive’s SCSI interface and refer to the ‘SCSI Cables, Storage Units, Controllers’ appendix for appropriatecable. Installing the 3623 on the same SCSI bus as on the SCSI devices may impact performance of those devices. Ships with an external 3m SCSI cable anda 2.8m/9ft, 100-120V, IEC 320-C13 to NEMA 5-15P line cord.4. Option P/N 18P9133 ships with a U.S./Canada 110v power cord. Option P/N 18P9484 is the same unit with a U.S./Canada 250v power cord.5. Rack installations require the 5U rack-mount kit P/N 18P9012.6. Does not ship with a power cord.7. Rack installations require the 2U rack-mount kit P/N 24R0998.8. 1U rack-mounted enclosure that supports one or two half-high tape drives. It allows each of these tape drives to be independently attached to asupported xSeries server or both to be daisy-chained to a single server. Includes two 3m 68-pin to.8mm VHDCI external cables.9. Desktop or rack tape enclosure which supports a single 133mm (5.25in) half-high tape drive. Requires a fixed shelf if installed in a rack (allow anadditional 1U for fixed shelf). Includes a power cord and an external 68-pin to 0.8mm VHDCI SCSI cable.10. Desktop or rack tape enclosure which supports a single 133mm (5.25in) full-high tape drive. Requires a fixed shelf if installed in a rack (allow anadditional 1U for fixed shelf). Includes a power cord and an external 68-pin to 0.8mm VHDCI SCSI cable.11. Requires 68-pin External Multimode LVD/SE SCSI Terminator (P/N 00N7956).12. Black desktop tape enclosure that supports a single 133mm (5.25in) half-high (HH) tape drive. Internal and external connectors are 68-pin high-densitysupporting LVD. External cables are not included. Refer to Appendix D: Cables - Storage Units - Controllers to select a supported cable.13. Black desktop or 3U rack tape enclosure supports a single 133mm (5.25in) full-high LVD tape device including DLT tape drives. Requires a fixed shelf ifinstalled in a rack (allow additional 1U for fixed shelf). Includes a 90w power supply, cooling fan, external terminator, power cord (country-specific), and2m 68-pin to 0.8mm external cable.14. Tape library attributes and prerequisites are located in Appendix B: Tape Library Attributes.15. 4560 Automation Tape Enclosure Library supports either LTO or SDLT (or both if the application software supports mixed media and the drives andmagazines are matched). Up to eight units can be stacked. Two magazines and two drive sleds can be installed in each unit. An external LVD SCSI cablewith 0.8mm VHDCI connectors at each end ships standard with the library unit. A single 300w power supply with an IEC 320-C13 to NEMA 5-15P lowvoltage power cord is standard.16. Data transfer speed is rated separately for LTO and SDLT media. Compressed speed may be less than the maximum rate provided.17. LTO and SDLT data cartridges are not provided standard. Cleaning cartridges are shipped standard with LTO and SDLT drive sleds.308 Configuration and Options Guide