configuration and options guide - IBM Quicklinks

Refer to the Important Notices section for important notices- 36232LX 200/400GB 2U LTO Generation 2 TapeAutoloader 3623 Model 2LX- 360716X 3607 Series 1760GB/3.5TB SDLTpro TapeAutoloader- 360726X 3607 Series 1.6TB/3.2TB LTO TapeAutoloader- 18P9133 TotalStorage Ultrium LVD Tape Drive 3580Model L23- 3581L28 TotalStorage Ultrium LVD Tape 2UAutoloader 3581- Ultra160 (16-bit) 2U Rack -- Ultra2 (16-bit) 2U Rack -- Ultra2 (16-bit) 2U Rack -- Ultra160 (16-bit) Stand-alone or 5U Rack 2 -- Ultra160 (16-bit) Stand-alone or 2U Rack 2- 3581F28 TotalStorage Ultrium Fibre Tape 2UAutoloader 3581External Tape Enclosures- 2Gb FibreChannelStand-alone or 2U Rack 2- 3510020 External Half-High SCSI StorageEnclosure 3, 4 - LVD (16-bit) Desktop -- 3503B1X 5Full-High SCSI Tape Enclosure - Ultra2 (16-bit) Desktop or 3U Rack -- 0034B0X 3NetBAY Tape Enclosure (Rack Mount) - Ultra2 (16-bit) 4U Rack -- 45591UX NetBay 1U xSeries Tape Enclosure - Ultra160 (16-bit) 1U Rack -External Tape Libraries 6- 18P9212 TotalStorage Ultrium LVD Tape Library3582 Model L23 3 - Ultra160 (16-bit) Stand-alone or 4U Rack 7 -- 18P9337 TotalStorage Ultrium Fibre Tape Library- 2Gb Fibre3582 Model F23 3 ChannelStand-alone or 4U Rack 7 -Associated Options- 00N7956 68-pin External Multimode LVD/SE SCSITerminator- LVD/SE (16-bit) External 351002024P7970 24P7973 Ultra320 External SCSI Connector CableOption 8 - Ultra320 LVD Internal -Note: Additional tape drive and tape library attributes, requirements and options can be found in the Tape Drive Attributes and TapeLibrary Attributes appendices, respectively.1. To determine external cable requirements, note the tape drive’s SCSI interface, the appropriate SCSI controller from the system configuratorsection and the desired enclosure, then refer to Appendix D: Cables - Storage Units - Controllers.2. Rack mount requires an optional rack kit. See tape drive appendix for more information.3. Requires 68-pin External Multimode LVD/SE SCSI terminator (P/N 00N7956).4. External cables are not included.5. An external cable is included.6. Tape library attributes and options are located in the tape library appendix.7. Rack mount kit is standard. Stand-alone kit is optional. See tape drive appendix for more information and options.8. Required to connect one channel of the integrated Ultra320 storage controller to the 0.8mm VHDCI external port, which cannot be enabled ifboth channels of the integrated controller are connected internally. If both SCSI channels are being used for internal use, an optional SCSI controlleris required to support external SCSI tape attachment.Chapter 9. xSeries 235 83