User's Guide - LINX Data Terminals

Sense Lines TestPlease Note:Control Lines TestPlease Note:Line1: “Testing COMx Receive at xxxxx BAUD”Line2: “RxPkts: xxxxxxxx RxErrs: xxxxxxxxx“Pressing the ‘EXIT” key will stop the test.This test will verify that the Sense lines operate.This test MUST be performed with a special test board installed on J7(Digital I/O Connector).This test will verify that the Control lines operate.This test MUST be performed with a special test board installed on J7(Digital I/O Connector).Vsmart FIU TestSee “Post AssemblyVerification in Appendix‘F’ for more information.This test will verify that the Bioscript Vsmart Fingerprint Identification Unit isconfigured correctly and is operational. A test card with a fingerprint template isrequired for this test.Ethernet Internal LpbkEthernet Host Ping TestThis test will verify that the Ethernet can operate in internal loopback via the Level-One(Intel) PHY I/F.This routine will execute the ICMP ping command to the user requested Host IPaddress. This IP address must be entered when prompted by the test.Reset PowerUPThis test will reset the terminal similar to a power-on.Reset to DefaultsNote: All user settings willbe lost except for networkparameters!This routine will reset the terminal configuration to defaults. Then the terminal will bere-booted after configuration has been saved.LINX 7-5 User's Guide Linx7-5 User Diagnostics • 25