QSDT4PCRC and QSDT8PCRS_web.pdf - Q-See

3.3 ALARM PORTInstall this dongle only if you wish to use external alarm sensors. The DVR card has built-inmotion detection software which can be used to trigger alarms when motion is detected by acamera.Use of this dongle will take up an additionalI/O port on the computer.To connect an alarm, you will need to attacha DB25 25-pin male solder cup and solderthe wires from the alarm to the cup. The pinorder is shown in Picture 3-10.3940PICTURE 3-10123.4 CONNECTING A PTZ CAMERAIn order to operate a PTZ camera from your computer, you will need to have first installed thecard into a PCI slot within the computer and attached the video dongle.You will also need an RS485 to RS232 (Serial) adapter as well as having a serial port on theback of your PC.PTZ CameraRS485 toSerial Adapter2PCPins highlighted in yellow in the chart below are only used by the QSDT8PCRS.Pin Port Define Interpret Pin Port Define InterpretPin1 Alarm_in1 Alarm Input 1 Pin21Pin2 Alarm_in2 Alarm Input 2 Pin22Pin3 Alarm_in3 Alarm Input 3 Pin23Pin4 Alarm_in4 Alarm Input 4 Pin24Pin5 Alarm_in5 Alarm Input 5 Pin25Pin6 Alarm_in6 Alarm Input 6 Pin26Pin7 Alarm_in7 Alarm Input 7 Pin27Pin8 Alarm_in8 Alarm Input 8 Pin28Pin9Pin29Pin10Pin30Pin11Pin31Pin12Pin32Pin13Pin33Pin14 Pin34 Alarm_Com Alarm COMPin15 Pin35 Alarm_NO Alarm Normal OpenPin16 Pin36 GND GroundPin17 Pin37 GND GroundPin18 Pin38 5V Power Source (5V)Pin19 Pin39 Alarm_NC Alarm Normal ClosePin20Pin4013 4PICTURE 3-11STEP 1. Connect the RS485 cables from the PTZ camera to the RS485-to-Serial AdapterSTEP 2. Connect the Adapter to the serial port on the back of the PCSTEP 3. Connect the video line from the camera to any Video In port on the DVR card(Item 4)You may now connect your camera to a power source.Please see Chapter 8 for instructions on operating the PTZ camera with the SuperDVRsoftware.CHAPTER 3 VIDEO CAPTURE CARD HARDWARE AND CONNECTIONS16 17