QSDT4PCRC and QSDT8PCRS_web.pdf - Q-See

Auto MailAny of the alarm types can be configured to generate an alert e-mail but it is especially usefulwhen triggered by a motion detection event.If Attachment is enabled,then a picture ofwhat triggered the alarm will be sent to theselected mailbox.NOTE! Before configuring the Auto Mail function, be sure to set up MotionDetection.Click the Auto Mail icon on the left top side of alarm configuration page to enter the AutoMail Setup Interface.PICTURE 7-10NOTE! Only one picture will be attached for each alarm event.7.3 E-MAP CONFIGURATIONE-map is used to show full geographic range covered by the whole monitoring system in theform of map. An E-map features simple operation and direct display of status.NOTE! The system only supports bmp or jpg image format for E-Map files.Users can set receiving and sending E-mailSMTP server and address. The addressof receiver and sender can be the same.However, this is not recommended as it canoverflow your e-mail account. Some freee-mail providers also place a daily limit onthe number of e-mails sent and received by asingle account.To test the settings, click Send Mail Test.If all settings are okay, response ‘MessageSent Successfully’ will pop up. If somesettings are wrong, a warning message willpop up.PICTURE 7-8Sender's E-mail AddressSender's SMTPReceiver's E-mail AddressPICTURE 7-9Sender's User NameE-mail SubjectSender's PasswordYou will need to draw the floor plan of whereyou want to install the cameras in a programsuch as Paint or Photoshop and save it inBMP or JPG format before using this feature.Files will be proportionally scaled to 833x678pixels when in use.Click on Emap Edit and then right-click inthe demonstration map currently displayed.Select Load Picture in the pop-up. Navigateto where the image is stored on yourcomputer and open the file. The map will bedisplayed in this interface, allowing you toadd the cameras to the map.Drag the icon of a camera to thecorresponding position on the map, amaximum of 32 cameras can be setsimultaneously, Click Change icon of cameraby right key to change icon or click Delete tocancel a camera. After editing, right-click inthe map display area and select Save Map inthe pop-up to save the current map.PICTURE 7-11PICTURE 7-1242 43CHAPTER 7 SYSTEM SETTINGS