QSDT4PCRC and QSDT8PCRS_web.pdf - Q-See

9.7 P.T.Z CONFIGURATIONClick the PTZ icon to configure the PTZ camera’s controlsMOBILE SURVEILLANCE CHAPTER 10This video surveillance card supports mobile surveillance on smart phones and other devicesrunning Android,Symbian and Windows Mobile Pro operating systems along with the iPadand iPhone on 3G networks. To access the card from these devices you must have firstconfigured your card for remote access as shown beginning with Section 9.2 ConfiguringRouter for Remote Access.10.1 WINDOWS MOBILE PROWindows Mobile Pro 6.1 and 6.5PROTOCOL SETUPProtocol - Communication protocol of P.T.ZdevicePort - Set the serial port numberAddress - The communication address ofP.T.Z device (ID number)PICTURE 9-64PICTURE 9-65STEP 1. Activate mobile network access on themobile phone.STEP 2. Run Internet ExplorerSTEP 3. Input the DVR’s IP address or DDNSdomainSTEP 4. You will be asked to download thesoftware PCam. Click on the software nameto open the download dialog pop-upSERIAL PORT SETUPYou should first enable the P.T.Z control function of selected camera and select a port numberin P.T.Z Protocol Setup and then set corresponding parameters. You should get the Baudrate, Protocol and Address from your PTZ camera or its manual before proceeding.PICTURE 10-1Port - Set the port numberBaud rate - Set the P.T.Z device Baud rate,default value is 9600, used value must matchBaud rate on PTZ control boardData bits - The default value is 8, used valuemuch match Baud rate on PTZ control board.Parity - Odd and even parity bit, default Null,used value must match Baud rate on PTZcontrol boardStop bits - Default value is 1, used value mustPICTURE 9-66match Baud rate on PTZ control boardNotice: Users should look into the P.T.Zdevice and get Baud rate, Protocol andAddress first, and then set other valuesaccordingly.By clicking Copy To you can copy the setting of this channel to any other selected channel.STEP 5. Click Yes to start downloading andinstalling.PICTURE 10-2CHAPTER 10 MOBILE SURVEILLANCE78 79