QSDT4PCRC and QSDT8PCRS_web.pdf - Q-See

STORAGE DISKYou can choose where to store recorded files by selecting storage disk. By checking theRecycle check box, users can setup the software to continue recording after the hard drive isfull by recording over the oldest files on the hard drive.By clicking Copy To you can copy the settingof this channel to any other selected channel.Mail setupSend to - Receiver’s E-mail AddressE-Mail from - Sender’s E-mail AddressSubject - E-mail SubjectYou can select the ‘Set Mail Internal’ checkbox to set e-mail send time, such as 5seconds, 10 seconds and so on.PICTURE 9-62PICTURE 9-58MOTION CONFIGURATIONClick the running figure icon to access the Motion Configuration interface.Sensitivity - Set motion detection sensitivityhere.Speed - Motion detection speedBlock number - Set grid’s numberSelect all - Select all the areas of the channelas detection areaClear all - Clear all the detection areasand then users can select customizeddetection areas using mouse curser.Attachment setupSelect ‘Attachment’ and the system will attach an image from the camera that triggered thealarm to the designated recipient.Camera - Channel NameTime - Display TimeFormat - Image FormatResolution - CIF or QCIFPICTURE 9-63PICTURE 9-59By clicking Copy To you can copy the setting of this channel to any other selected channel.E-MAIL CONFIGURATIONClick the E-mail icon to access to E-mail Configuration interface.Mail server setupIn this area, users can set receiver andsender’s E-mail SMTP server and address.Note: the address of receiver and sender canbe the same.SMTP server - Sender’s SMTP, such assmtp.yahoo.comUser name - Sender’s User NameSMTP PORT - Mail server’s port, the defaultvalue of mail server is 25.Password - Sender’s PasswordYou can select ‘My server requires a secureconnections’ or ‘My outgoing server(SMTP)requires authentication’ check boxaccording to server mail service policy of mailservice provider.PICTURE 9-60PICTURE 9-6176 77CHAPTER 9 REMOTE SURVEILLANCE & PLAYBACK