QSDT4PCRC and QSDT8PCRS_web.pdf - Q-See

RECORDING, PLAYBACK ANDRECORD SEARCHCHAPTER 66.1 RECORDING CONFIGURATIONThe system can be set to record in four different modes; scheduled recording, manual recording,motion detection and sensor alarm.Once you have logged into your system, you can access the control settings through theConfiguration window by clicking on the wrench icon located on the left of the Main DisplayInterface.Upon accessing the Configuration window, the icons on the left will change as will the contentsof the Display Window.BASIC CONFIGURATIONThe Record Panel, in the bottom half of the Basic Configuration page, allows users to setrecording modes along with other parameters for each camera. More than one recordingmode can be activated at one time.It should be noted that the higher the recording quality and frame rate, the more space therecorded file(s) will occupy on the hard drive.Basic ConfigurationVideo configurationAlarm ConfigurationUser ConfigurationPICTURE 6-1Schedule configurationMotion Detection ConfigurationP.T.Z ConfigurationSave and ReturnPICTURE 6-2Time Stamp - By selecting this option, the record date / time message appears in therecorded file images.Switch - Turns on corresponding cameras. If there is no camera on a channel, do not selectthis option and you will save system resources.Manual Record - Images from the selected camera will be recorded and saved all the time(24 hour recording).Manual Recording Frame Rate - Select the recording frame rate for manual record mode.Schedule Record - This option allows you to record on a set schedule.Schedule Record Frame Rate - Select Schedule Recording frame rate.Motion Detection - By selecting this option, users can set the selected channels to recordwhen motion is detected in front of the camera.Motion Record Frame Rate - Select recording frame rate for Motion Detection record mode.Sensor Record Frame Rate - If sensors are utilized to trigger recording, users can selectrecording frame rate here.Camera Security - Users are divided into three types: Normal user, Power user andAdministrator. By selecting this option, only administrators can see the selected channels.Record Quality - Select recording image quality here.Audio In - SuperDVR 6.3 can support one channel of microphone audio input signal on thePC motherboard and any audio inputs that are on the card if any. Users can choose one videochannel for each available audio input.CHAPTER 6 RECORDING, PLAYBACK AND RECORD SEARCHFor the purposes of this chapter, we will only be concerned with; Schedule Configuration,Video Configuration and Motion Detection Configuration. The remaining functions will becovered in Chapter 7.24 25