VL1100 ERS Luminaires User's Guide - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - VL1100 ERS LUMINAIRE USER’S MANUALPower and Data Cabling RequirementsAC PowerWARNING: Other than described herein, do not power a VL1100 ERS Luminaire from a dimmedcircuit - even in "Non-Dim" mode. Dimmer and non-dim modules are not suitable sources of powerbecause their output modifies the AC wave form. This may work for a short time, but will eventuallyresult in power problems, luminaire mis-operation and/or failure. Using a dimmer or non-dim moduleto power your VARI❋LITE® luminaire will void your luminaire’s warranty.The luminaire requires standard AC power distribution from 90-264 VAC, 50/60 Hz in order to powerall internal electronics and motors. It is equipped with a 3-pole Neutrik® PowerCon® lockingconnector (with contacts for line, neutral, and premating safety grounds) for the purpose of AC input.The mating Neutrik PowerCon® connector is supplied, however, you will need to purchase orconstruct a cable appropriate for your application.Neutrik PowerConConnector (supplied)Figure 2-1: Power Connector3-Pole NeutrikLocking Connectorfor AC inputCurrent vs. VoltageThe following tables provide the luminaire’s current draw at specific voltages. (Currents given areworst case with all motors sequencing.)Table 2-1: VL1100TS/VL1100TI Current vs. Voltage *Voltage @ 60Hz Current115 1.3 A208 0.75 A230 0.65 A* Does not include lamp power.14 04 November 2009 02.9664.0001 0
INSTALLATION : POWER AND DATA CABLING REQUIREMENTS2Table 2-2: VL1100AS/VL1100AI Current vs. Voltage **Voltage @ 60Hz Current115 7.8 A208 4.4 A230 3.8 A** Includes ballast power.Table 2-3: VL1100TSD/VL1100TID Current vs. Voltage ***Voltage @ 60Hz Current115 10ATable 2-4: VL1100TSD230/VL1100TID230 Current vs. Voltage ***Voltage @ 60Hz Current230 5A*** Includes lamp power.Lamp PowerWARNING: Other than described herein, do not power a VL1100 ERS Luminaire from a dimmedcircuit - even in "Non-Dim" mode. Dimmer and non-dim modules are not suitable sources of powerbecause their output modifies the AC wave form. This may work for a short time, but will eventuallyresult in power problems, luminaire mis-operation and/or failure. Using a dimmer or non-dim moduleto power your VARI❋LITE® luminaire will void your luminaire’s warranty.Lamp power for the VL1100 lamp is supplied in one of three ways depending on model configuration:• External dimmer (incandescent units without on-board dimmer - supplied by others).• Internal dimmer (incandescent units with on-board IGBT dimmer).• External ballast (arc units).02.9664.0001 0 04 November 2009 15
Page 2 and 3: VARI❋LITE® is a trademark owned
Page 4 and 5: VARI❋LITE® - VL1100 ERS LUMINAIR
Page 82 and 83:
VARI❋LITE® - VL1100 ERS LUMINAIR
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96:
show all

VL1100 ERS Luminaires User's Guide - Vari-Lite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?