VL1100 ERS Luminaires User's Guide - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - VL1100 ERS LUMINAIRE USER’S MANUALDMX Termination ConnectorA male XLR DMX termination connector is required at the last luminaire(or "far end of the line") to prevent signal reflections. Signal reflectionsmay cancel out the signal at certain line lengths, resulting in errors. Theterminator is also necessary for software downloads and running tests onmultiple luminaires. To construct your own connector, you will need thefollowing components:• 5-pin, male XLR connector.• Two 1/4W 5% 120 ohm resistors.12 43Solder resistors acrosspins 2 & 3, and 4 & 55Note: A male termination connector is available as an accessory from Vari-Lite. See “Accessories” onpage 12.Loopback ConnectorWhen transferring software versions from luminaire to luminaire, aloopback connector is required at the first luminaire in the data link.To construct your own connector, you will need the followingcomponents:• 5-pin, female XLR connector.• Two small segments of 22 AWG wire.543Solder wires acrosspins 2 & 4, and 3 & 521Note: A loopback connector is available as an accessory from Vari-Lite. See “Accessories” onpage 12.20 04 November 2009 02.9664.0001 0
INSTALLATION : INSTALLATION PROCEDURES2Installation ProceduresInstalling Lamp (Incandescent Models)In the event the lamp was packed separately during shipment, it will be necessary to install before use.WARNING: Ensure that power is removed from luminaire when installing lamp.CAUTION: Wear cotton gloves or other covering while installing lamp. Touching lamp glass withbare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, usealcohol and cotton cloth to thoroughly clean glass portion of lamp.To install incandescent lamp:Step 1. Ensure power is removed from luminaire.Step 2. At backcap, gradually loosen two 10-32x2-3/8" PPSS black screws (Figure 2-4) a few turnsat a time until backcap is free. (Screws must be alternately loosened to prevent one side fromlocking up.)BackcapInterior ViewRear HeadAssemblyCAUTION:Do not touch lampwith bare fingers.BackcapAlign whenre-installingAlignment Stud (2)CAUTION:Alignment Hole (2)Holes and studs MUST bealigned when re-installing.10-32x2-3/8 PPSSBlack Screws (captive)- loosen each graduallyFigure 2-4: Removing Incandescent Backcap02.9664.0001 0 04 November 2009 21
Page 2 and 3: VARI❋LITE® is a trademark owned
Page 4 and 5: VARI❋LITE® - VL1100 ERS LUMINAIR
Page 88 and 89:
VARI❋LITE® - VL1100 ERS LUMINAIR
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96:
show all

VL1100 ERS Luminaires User's Guide - Vari-Lite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?