VL1100 ERS Luminaires User's Guide - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - <strong>VL1100</strong> <strong>ERS</strong> LUMINAIRE USER’S MANUALRoutine MaintenanceCleaning Optical Lenses and GobosWARNING: Remove power from luminaire before performing maintenance.The front lens and gobos may require cleaning after extended use. Use only isopropyl alcohol, alongwith a soft, lint-free cloth to clean glass components.To access gobos, refer to procedure below.Rotating Gobo ReplacementWARNING: Remove power from luminaire before performing maintenance. Gobos may be HOTafter operation. Allow to cool before replacing.WARNING: Users of VARI❋LITE® luminaires should not install or use metal gobos.The use of metal gobos in any VARI❋LITE® product may damage the luminaire andcould void the luminaire’s warranty.To replace a rotating gobo:Step 1. Remove power from luminaire.Step 2. At either side of head assembly, press in front cover latch and pull cover straight back untilstopped by tether.Step 3. Rotate gobo wheel until required gobo position is accessible at finger access cutout.Step 4. Rotate gobo gear until open end of carrier is upward.CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering whilereplacing. Clean with isopropyl alcohol and soft, lint-free cloth if required.CAUTION: Do not pull metal spring clip carrier back too far or it will not close properly.StepStep5. If applicable, carefully pull current gobo up and out of carrier. Gobo can be easily scratchedon sides of carrier if not careful.6. Carefully install new gobo, orienting side marked "This Edge In" toward center of gobowheel and side marked "Lamp Side" (mirror finish) toward lamp. Gobo can be easilyscratched on sides of carrier if not careful. Ensure gobo is firmly set in carrier grooves.72 04 November 2009 02.9664.0001 0
TROUBLESHOOTING AND MAINTENANCEAStep7. Re-install front cover.CAUTION:Gobo MUST be oriented with the mirroredside towards the luminaire’s lamp. If notoriented properly, gobo will break.Be careful not to scratch gobo on side ofcarrier when installing.Inside Edge- orient toward center of wheelLamp Side (mirrored)- orient toward luminaire lampClosed EndRotate until openend of carrier is upGearOpen EndFront CoverGobo PositionsSensor21open635Gobo(black side)LatchGobo Wheel Front View4Lamp EndRotatingGobo WheelCAUTION:Be careful not to pull metal spring clip carrierback too far or it will not close properly.Center of WheelFigure A-1: Rotating Gobo Replacement/Cleaning02.9664.0001 0 04 November 2009 73
Page 2 and 3:
VARI❋LITE® is a trademark owned
Page 4 and 5:
VARI❋LITE® - VL1100 ERS LUMINAIR
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41: VARI❋LITE® - VL1100 ERS LUMINAIR
Page 96: VARI❋LITE® - VL1100 ERS LUMINAIR
show all

VL1100 ERS Luminaires User's Guide - Vari-Lite

Create successful ePaper yourself

Delete template?

Save as template?