VL1100 ERS Luminaires User's Guide - Vari-Lite

VARI❋LITE® - VL1100 ERS LUMINAIRE USER’S MANUALStandard Power Up ProcedureUse this procedure when powering up a luminaire that has already been configured. (Refer to “Power-Up and Configuration Overview” on page 31.)Note: Refer to Chapter 4: Menu System for detailed instructions on menu functions.CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head andyoke can move freely without restriction.To power up luminaire:Step 1. At each luminaire, apply power by switching on power source. Luminaire will displayStarting for 10-15 seconds, and then automatically step through the following procedure:a. For Arc lamps:1) If Lamp Power-Up State is set to Lamp On, lamp will strike (ignite).2) Luminaire will cycle through calibration and stop at "home" position.3) If Lamp Power-Up State is set to Cal On, lamp will strike (ignite) at end ofcalibration sequence.b. For Incandescent lamps:1) Luminaire will cycle through calibration and stop at "home" position.32 04 November 2009 02.9664.0001 0