VL1100 ERS Luminaires User's Guide - Vari-Lite

More documents

Recommendations

Info

VARI❋LITE® - <strong>VL1100</strong> <strong>ERS</strong> LUMINAIRE USER’S MANUALSelf TestsRunning Parameter TestsThe luminaire is capable of running self tests by using the TEST menu functions.Note: If a DMX data stream is present on the luminaire’s DMX input connector, Self Test and Manualcontrol is overwritten by the DMX command protocol and neither (Self Test and Manual) will operate.When running tests on multiple luminaires, a loopback connector is required at the master luminaire(first in link) and a male termination connector is required at the last luminaire in the link. Refer topage 20 for more information regarding the construction of these connectors.Note: After 10 seconds of inactivity, the menu display will change to the default state showing theaddress.To connect luminaires for simultaneous testing:Step 1. At first luminaire in link, install loopback connector into DATA IN XLR connector.Step 2. At last luminaire, install DMX termination connector into DATA THRU XLR connector.Step 3. At master luminaire Menu Display, press [Menu].First luminaire containingsoftware version to downloadLuminaire 1requiring updateLuminaire 2requiring updateData ThruData ThruLoopback ConnectorDMX Termination ConnectorFigure 4-1: Hardware SetupTo run tests:Step 1. Press [Menu].Step 2. Press [Up] / [Down] arrows until Test appears. Press [Enter].Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to “Menu System FunctionChart” on page 61 for a complete list of test parameters which can be chosen.Step 4. Press [Enter] to run test.Step 5. Press [Menu] to stop test at any time.66 04 November 2009 02.9664.0001 0
MENU SYSTEM : SELF TESTS4Movement DisableThe Movement option allows pan and tilt to be disabled so that the luminaire can be placed in anyposition for testing without movement occurring. In order to regain full control of the luminaire,Movement will need to be enabled after testing.Note: When using the Movement option, pan and tilt will be disabled for all the luminaires that arelinked.To set movement option:StepStepStepStepStep1. Press [Menu].2. Press [Up] / [Down] arrows until Config appears. Press [Enter].3. Press [Up] / [Down] arrows until Pan/Tilt appears. Press [Enter].4. Movement will be displayed. Press [Enter].5. Use [Up] / [Down] arrows to select Enable or Disable. Press [Enter] to select.02.9664.0001 0 04 November 2009 67
Page 2 and 3:
VARI❋LITE® is a trademark owned
Page 4 and 5:
VARI❋LITE® - VL1100 ERS LUMINAIR
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35: VARI❋LITE® - VL1100 ERS LUMINAIR
Page 96: VARI❋LITE® - VL1100 ERS LUMINAIR
show all

VL1100 ERS Luminaires User's Guide - Vari-Lite

Create successful ePaper yourself

Delete template?

Save as template?