2 - Asante

General Network ConfigurationThe Add Threshold Table Entry window, as shownin Figure 7-14, appears.Figure 7-14Add Threshold Table Entry window▲ If you already have four entries in the table, you willnot be able to add more.Add a threshold entry by filling in the fields. Table 7-2provides instructions.Field NameAliasTargetGroupNumberTable 7-2Port NumberOwner StringSubjectValueIntervalConditionAdd Threshold Table Entry InstructionsInstructionsAlias of selected device.Select Hub, Segment, Group, or Port from the popup menu asthe target to be polled for the threshold.Select the appropriate group number from the popup menu.The contents of the popup menu depend on the device youhave selected.Enter the number of the port if you selected Port as the target.This field is inactive if you selected the hub as the target.Not modifiable. The IP address of your device will appear inthis field after you enter the table entry in the Modify ThresholdTable Entry window.From the popup menu, select the counter type to be polled. Theavailable subjects are: Good frames, Multicast, Broadcast,Frame too long, Runts, Alignment error, Fragment, FCS errors,IFG errors, DRM errors, Short event, Collision, Late collision,Auto partition, SFD missing, Bad frames.Enter the number for the threshold water mark.Enter the value in seconds for the polling interval.From the popup menu, select Rise, Fall, or Rise + Fall toindicate whether the trap is sent when the event rate exceedsor falls below the threshold, or both.Page 7-22