2 - Asante

Using the Panel ViewTo display bridge port utilization, follow with clicking Utilization inthe Network Analysis submenu (located in the Performancemenu).To display bridge port statistics, follow with clicking All Port Monitorin the Network Analysis submenu (located in the Performancemenu). For more information, see "Utilization Tool" onpage 8-16.Hub Map LabelDisplays the label assigned to this hub in the current map.The alias can be edited with the Map Editor; the IP address anddevice name can be edited in the Set Agent Parameters window.Hub Utilization DisplayDisplays the amount of packet traffic handled by the hub; the bottomrow of LEDs turn on when a collision or a bad packet occurs ona hub port.Hub CPU Status DisplayShows CPU activity for the hub CPU. This LED should always beblinking. If the LED is continuously on or off, a problem exists onthe hub.Hub Port SelectorsDisplays graphic images of each of the twelve 10BaseT ports on thehub. It does not matter if you are using RJ45 connectors pluggedinto the hub front panel or one RJ21 connector plugged into therear of the hub. The selectors apply to ports 1–12, regardless of theconnection method used.Click any port to select that port for control and monitoring functions(accessible from the AsantéView main menu bar).Hub Status DisplayDisplays the hub partition (bottom row) and link status (top row)for each of the hub’s 10BaseT ports.The display reports data for the ports regardless of whether they areconnected via RJ45 connectors on the front panel or a single RJ21connector on the rear panel.Page 3-16