2 - Asante

AsantéHub 1012AsantéHub 1012 You can view and change the configuration of an AsantéHub 1012directly from its on-screen front or back panel view.To open the hub front panel view, double-click its icon on the map.Figure 3-1 shows an example of an AsantéHub 1012 front panel view.Hub CPU status displayHub utilization displayHub map labelHub port selectorsPort status displayHub typePanel view selector;changes image to back viewFigure 3-1AsantéHub 1012 Front Panel ViewThe following paragraphs describe the elements of the AsantéHub 1012front panel view.Hub Port SelectorsDisplays graphic images of the hub’s twelve 10BaseT ports. Theselectors apply to ports 1–12, regardless of the connection methodused (RJ45 connectors in the front panel or an RJ21 connector inthe rear).To control and monitor a port, click the port and use theAsantéView main menu bar.Hub Map LabelDisplays the label assigned to this hub in the current map.The alias can be edited with the Map Editor; the IP address anddevice name can be edited in the Set Agent Parameters window.Hub Utilization DisplayDisplays the amount of packet traffic being handled by the hub; theLEDs in the bottom row turn on when a collision or bad packetoccurs on a hub port.Hub CPU Status DisplayShows CPU activity for the hub CPU. This LED should always beblinking. If the LED is on or off continuously, a problem exists onthe hub.Port Status DisplayDisplays the port partition and link status for each 10BaseTport. The display reports data for each port regardless of whether anRJ45 connector is used on the front panel or a single RJ21 connectoris used on the rear panel.Page 3-3