MC-Balance User Manual 4.0.UK.00

7.4 ConfigurationFor initial setup the MC-Balance controller needs to be configured in the CONFIGURATIONmenu once. Depending on the configuration, some settings will be invisible in case they are notrelevant.i Highlighted Parameters are factory settings.Language : ENG / DEMotor type : LT / HTCylinder type : GX / GLX / HX / A20 / A30Material type : NORMAL / MICROCal dev. : 5,0 %Control mode : GRAVI / RPMProd. Mode : INJ / EXTInput mode : Timer / Relay / TachoFill. System : NO / ME / MV / EX└ EX HH level : 3500 gr.└ EX H level : 2500 gr.└ Filling start : 800 gr.Hopper empty : 700 gr.Deviationalarm : 25 %Jobs enabled : NO / YESAuto start : NO / YESMaster reset : NONE / ALARM / MATER / JOBS / ALLIP : xxx . xxx . xxx . xxx (For example: 192.168.001.001)Name: xxxxxxxxxxxxxxStart user : Operator / Tooling / SupervisorTooling passw. : xxxx 1111Supervisor passw. : xxxx 2222Conversion : Metric / Imp / kg/hFull scale: xx.xx kgModbus unit : 1-231Date: (dd / mm / yy)Time: (hh / mm / ss)Configuration: LanguageStandard language is English. On request also different languages are available.Configuration: Motor typeLT is Low Torque motor and HT is High Torque motor (see chapter 5 for more information)i Do not select HT motor if LT motor is connected.Configuration: Cylinder typeType of dosing cylinder / feed screw (see chapter 5 for more information)Configuration: Material typeType of material, normal granules (NORMAL) and micro granules (MICRO).(see chapter 5 for more information)Configuration: Cal dev.The maximum allowed deviation from the Calibration Setpoint can be set with thisParameter. (For more information see chapter 7.6)15MC-Balance manual