MC-Balance User Manual 4.0.UK.00

How to make a material calibration?• Go to the CALIBRATION menu.• Enter Material name and your production parameters.• Start calibrating. The following screen appears:CALIBRATION[TESTING BUSY][*****]Set : 1,000 gr/sActual : 0,945 gr/sStop & Store : YES/NO• The calibration will take minimal about 3 minutes but can take more time depending on theused material and production parameters.It is possible to stop during the calibration (for example to refill the hopper).To continue select YES and confirm. To stop select NO and confirm.• The calibration will automatically be finished and saved after the Setpoint is reached within theset calibration deviation (Cal dev: default = 5%) set in configurations menu. (see chapter 7.4)• After saving you will automatically go to the PRODUCTION menu and stored calibration isautomatically selected.iStored material curves have a * after the filename.During the calibration the unit is regulating to his Setpoint. When this point is reached thecalibration will be saved automatically. On the basis of this point a complete curve is made onbases of default pre-programmed curves.Material CalibrationSingle point calibration on basis of preprogrammedMOVA-curveIt is also possible to save the actual material calibration during a running production process.This function is called the “Save data Function”, for more information see chapter 7.8How can I select a calibrated material?When one or more material calibrations are made, one of these can be selected as follows:• Go to PRODUCTION • Use the cursor to go to Material.• Press 2 seconds on the buttonA list will appear with stored material calibrations• Select one with arrow buttons and confirmIf the material calibration made is not in the list fill in the first letter(s) and confirm. Now a filtered listappears. To go back to the main list fill in spaces and confirm.It is also possible to fill in the material description immediately in the PRODUCTION andconfirm. The message “Material not found, select new material” appears when a false materialis filled in. To clear the material description fill in spaces or select an empty material calibration outof the list.How can I delete or rename a calibrated material?To delete one or more material see chapter 7.13.To delete all Materials select master reset MATERIAL in the CONFIGURATIONS andconfirm.23MC-Balance manual