MC-Balance User Manual 4.0.UK.00

INJECTION MOULDINGThe following parameters can be seen in the production screen, depending on operation orsettings (made in supervisor mode):Injection molding / Gravimetric modeProduction SettingsPRODUCTION SETTINGSRef.Curve: MOVA/USERProd Job : xxxxxxxxMaterial : xxxxxxxxColor % : x.xxx %Shot wth.: xxxx.x grDos.time : xx.x sSave job : NO/YESTest : NO/YESRef.Curve: Type reference curve, MOVA pre-programmed curve, or USER defined curve.Prod Job : Name of the production JobMaterial : Name of material calibrationColor % : Color amount (%)Shot wth : Shot weight (gr.)Dos. time : Dosing time (sec.) iDosing time only visible in Timer modeSave job : Save actual production settings into a jobTest: : Initial production test with set speed and timeActual production dataPRODUCTION DATACol.Set. : x.xxx gr/sCol.Act. : x.xxx gr/sHopper : xxxx gr >< : Standstill sign. When the vibrations are too big, this sign disappears!Time : -count down of the actual dosing time (sec), when working TIMER input mode.-average dosing time (sec), when working in RELAY input mode.Speed : Actual motor speed (RPM)Status : Status of the dosing, Standby / Dosing / FillingInjection molding / RPM modeProduction SettingsPRODUCTION SETTINGSProd Job : xxxxxxxxSet speed: xxx.x rpmDos.time : xx.x sSave job : NO/YESTest : NO/YESProd Job : Name of the production JobSet speed : Set motor speed (RPM)Dos.time : Actual dosing time (sec), measured from relaySave job : Save production settings into a jobTest: : Initial production test with set speed and timeActual production dataPRODUCTION DATASpeed : xxx.x rpmTime : xx.x secSpeedTimeStatus: Actual motor speed (RPM): Count down of the actual dosing time (sec): Status of the dosing, Standby / dosing / fillingi RPM mode needs always a set dosing time, relay function is not functional.Status : Dosing25MC-Balance manual