MC-Balance User Manual 4.0.UK.00

More documents

Recommendations

Info

3. Overview Dosing unit3.1 MC-Balance Component overview1051 2.3 46.7 891 Stepper motor2 Dosing system (Dosing cylinder)3 Hopper 6 ltr4 Curled knob M10x405 Standard NST40 Neckpiece6 Material discharge slide (in closed position)7 MC-Balance Load frame8 OPTIONAL Slide frame9 Slide locking bolt(locking the slide-out position)Only supplied together with the optional slide mechanism10 Slide locking bar(locking the slide-in position)Only supplied together with the optional slide mechanism3MC-Balance manual
3.2 Weighing frameTransport protectionSafety bolts (total of 4)Hopper loader tube supportBalance frameThe black part is the weighing frame.Do not touch this weighing frame (and dosing unit) while dosing.It will have influence on the dosing.Do not touch the safety bolts under the weighing platform. These are for overload protection.There must be some space between de safety bolts and the frame.3.3 Motor and dosing systemThere are mainly two dosing systems, the dosing cylinder and the feed screw.(for more information see chapter 5)The serial number of the motor can be found on thebackside of the motor.Motor axle:The motor shaft is equipped with one flat side whichfits exact in shaft of the dosing cylinder.To connect the dosing cylinder just put it on themotor axle while turning it to find the flat side, thanpress the dosing cylinder completely backwards.4MC-Balance manual
Page 1: MC-BalanceUser Manual 4.0.UK.00Soft
Page 4 and 5: 1. IntroductionThank you for purcha
Page 8 and 9: 4. Metering principleThe Dosing Cyl
Page 10: All Movacolor dosing units are stan
Page 14 and 15: APPENDIX A SHOWS THE PRINT VIEW WHI
Page 16 and 17: 7.2 Start up & LoginDirectly after
Page 18 and 19: 7.4 ConfigurationFor initial setup
Page 20 and 21: The maximum voltage that can be app
Page 22 and 23: Configuration: DeviationalarmSettin
Page 24 and 25: 7.5 Loadcell calibrationWhen using
Page 26 and 27: How to make a material calibration?
Page 28 and 29: INJECTION MOULDINGThe following par
Page 30 and 31: 7.8 Auto/Manual regulation mode & S
Page 32 and 33: 7.10 Filling the hopper.MANUAL FILL
Page 34 and 35: GeneraliThe hopper loader is only a
Page 36 and 37: Recommended settings for ME hopper
Page 38 and 39: WARNINGSAll warnings are self elimi
Page 40 and 41: 7.14 Event LOGSetting changes made
Page 42 and 43: 9. Trouble shootingProblem : The ba
Page 44 and 45: 41MC-Balance manualPOTENTIAL FREE P
Page 46 and 47: APPENDIX D: MC-Bal. Drawings Genera
Page 48 and 49: General dimension MC-Balance + MV25
Page 50 and 51: APPENDIX E: MC-Bal. Decl. of Confor

MC-Balance User Manual 4.0.UK.00

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?