MC-Balance User Manual 4.0.UK.00

EXTRUSIONExtrusion / Gravimetric modeProduction SettingsPRODUCTION SETTINGSRef Curve : MOVA/USERProd Job : xxxxxxxxMaterial : xxxxxxxxColor % : x.xxx %Ext.cap : xxxxx.x kg/hMax tacho: xxx,x vSet tacho: NO/YESSave job : NO/YESTest : NO/YESRef.Curve: Type reference curve, MOVA pre-programmed curve, or USER defined curve.Prod Job : Name of the production JobMaterial : Name of material calibrationColor % : Color amount (%)Ext.cap : Maximum extruder capacity (kg/h)Max tacho : Maximum tacho voltage (v) ionly visible in Tacho modeSet tacho : Autom. voltage take over from tacho generator ionly visible in Tacho modeSave job : Save production settings into a jobTest: : Initial production test with set speed for 30 seconds.Actual production dataPRODUCTION DATAExt.act. : xxxxx.x kg/hAct tacho : xxx,x vCol. Set. : x.xxx gr/sCol. Act. : x,xxx gr/sHopper : xxxx gr >< : Standstill sign. When the vibrations are too big, this sign disappears!Speed : Actual motor speed (RPM)Status : Status of the dosing, Standby / Dosing / FillingExtrusion / RPM modeProduction SettingsPRODUCTION SETTINGSProd Job : xxxxxxxxSet speed xxx.x rpmMax tacho: xxx.x vSet tacho: NO/YESSave job : NO/YESTest : NO/YESProd Job : Name of the production JobSet speed: Set motor speed (RPM)Max tacho : Maximum tacho voltage (v)ionly visible in Tacho modeSet tacho : Autom. voltage take over from tacho generatorionly visible in Tacho modeSave job : Save production settings into a jobTest: : Initial production test with set speed and timeActual production dataPRODUCTION DATAAct tacho : xxx.x vSpeed : xxx.x rpmAct tacho : Actual voltage of the tacho generator (v) ionly visible in Tacho modeSpeed : Actual motor speed (RPM)Status : Status of the dosing, Standby / dosing / fillingStatus : Dosing26MC-Balance manual