Power Spot 250 User Manual (pdf) - Elation Professional

Power Spot 2506. Lamp ReplacementFor a proper and safe lamp change, please read this chapter carefully and follow allinstructions.6.1 Safety Regulations• Pull out the main plug!• Wait min. 20 minutes after the last operation to cool down the fixture.• Don’t touch the bulb of the lamp with bare fingers (this can cause damages.• Before you put the POWER SPOT 250 into operation close the casing, otherwiseyour retina can be hurt!6.2 Lamp Change6.2.1 Be sure the unit is disconnected from it’smain power supply.6.2.2 Remove the upper shell of the protectivecover by removing the 4 retaining Phillipsscrews, 2 located on the front and 2 locatedon the rear of the head.6.2.3 Once the outer cover has been removed,expose the lamp by removing the lampcover plate. Remove the lamp cover plateby unscrewing 3 thumb screws. Refer tothe illustration on the left.6.2.4 Gently remove the old lamp from it’s socket.If the old lamp has exploded be sure toremove all of the old lamp fragments toprevent damage to the internalcomponents.fastening screwlamplampcover plate6.2.5 Replace the lamp with an approved replacement type. Be sure to follow all thelamp handleing procedures included with your new lamp. Never handle the newlamp with your bare hands, the oils from your skin may damage the lamp. Alwaysreplace with the lamp with a lamp that meets the orginal lamp specification, failureto do so may damage the unit and will void your manufactures warranty.6.2.6 Before reassembing the unit, be sure to adjust the lamp distance from the main©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 33