Power Spot 250 User Manual (pdf) - Elation Professional

Power Spot 2506.3.1 Strike the lamp (through the internal menu functions or with a DMX controller) andwait a while until full intensity of the lamp.6.3.2 Using either a DMX controller or the control panel on the unit, strike the lamp andfocus the light on a flat surface.(beam open, white, no gobo, no effects).6.3.3 Center the hot-spot (the brightest part of the beam) using the 3 adjustmentscrews. Turn one screw at a time to drag the hot-spot diagonally across theprojected image. If you cannot detect a hot-spot, adjust the lamp until the light iseven.6.3.4 To reduce a hot-spot, pull the lamp in by turning all three screws clockwise 1/4-turn at a time until the light is evenly distributed.6.3.5 If the light is brighter around the edge than it is in the center, or if light output islow, the lamp is too far back in the reflector. “Push” the lamp out by turning thescrewsNOTICE: Be sure the minimum distance between the lamp and lens is at least 1.0mm. Ifthe distance between the lamp and lens is less then 1.0mm, the lens may shatter due toexcessive heat built-up.©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 35