Power Spot 250 User Manual (pdf) - Elation Professional

Power Spot 250depends on the environment in which the fixture operates (I.E. smoke, fog residue,dust, dew). In clubs that observe heavier use, we recommend cleaning on a morefrequent basis. Periodic cleaning will ensure fixture longevity and crisp lamp output.Attention:1. Never allow optical parts come into contact with oil, dirt, or grime.2. Allow all parts to dry completely before attempt operation.3. Never clean the aspheric lens with water or other cleaners. The lensshould be changed at the first sign of ware, usually in about 1 – 2 years(lens will begin to look cloudy). For lens replacement please contactElation technical support.9.3 Cleaning the Optical System (recommended for authorized personal only)9.3.1 Always disconnect main power before attempting any service relatedissues!9.3.2 Allow ample time for the lamp to cool (at least 20 minutes) beforeperforming any cleaning procedures.9.3.3 Open and remove the upper half of the projector by loosening the 4 retainingPhillips screws. Two located on the front and 2 located on the rear of thehead.9.3.4 Follow the chart above to complete the service procedures.9.3.5 Replace the shell and tighten the 4 retaining screws.9.3.6 Be sure the cover has been replaced and all the parts have completely driedbefore attempting operation.©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 40