Hydraulic cylinder Tie Rod Design - imperial - Duncan Rogers

PARTS LISTFront Flange MountsRear Flange MountsFoot Bracket MountStyle FFStyle FFXStyle RFStyle RFXStyle FBClevis MountIntermediate Trunnion MountEnd Lug MountStyle CStyle TStyle ELItem Description Qty.No.Req’d.117 Intermediate Trunnion 1130 Intermediate Trunnion Screw 1108 ■ End Lug – Front 1109 ■ End Lug – Screw 2110 ■ End Lug – Rear 1BoreZero StrokeAdd Per Inchof Stroke1 1 /83.251 1 /28.5214.8HH Series Cylinder Weight Chart2 1 /2191.33 1 /4371.8 Not available on 10", 12" and 14" borecylinders.Note: The above weights are based on an average value for cushioning, rod size, and the various typesof mountings for uncrated cylinders to establish approximate shipping weights. Add 10% of cylinderweight to determine estimate weight of crated cylinder. Weights given in Ibs.4502.5590461405.872106.5829091065016129752514160035Item No. Description Qty .Req’d100 Front Flange 1102 Front Flange Extra 1103 Rear Flange 1104 Rear Flange Extra 1105 ■ Foot Bracket – Front 1106 ■ Foot Bracket – Screw 2107 ■ Foot Bracket – Rear 1112 Clevis Pin 1Complete replacement packing kits are available.For purposes of economy and less down-time, itis recommended that replacement packing kitsbe stocked. Contact factory for further details.ROD END INFORMATIONStandard – Style 2 Alternate – Style 4KK THREADNA DIA.KF THREADAWFWFFWFV BBDIA.MM DIA.BDIA.NADIA.MM DIA.D WRENCHF L AT SMale thread with adequateshoulder for locking accessory.ACVAORVD WRENCHF L AT SCVAORVFemale thread, used with male accessoriesfor shorter overall cylinder length.VSquareGland RetainerVAFARoundGland RetainerAlternate – Style 1 Alternate – Style 6BDIA.20˚1 / 8+ 1 /16- 0CMM DIA.VAORVPlain male Rod End with no threads. Usedfor pushing, holding, knock-outs, etc.BDIA. AFDIA.AEADACMM DIA.VAORVUsed with S.A.F.E. accessory (see accessorypage 7) for fast, close radial alignment.ImportantSpecify on order1. Type of thread2. Length of thread3. Rod extension if non-standard4. Any non standard thread please4. supply full details5. Style 6 For use only on fixed mountings.5. Under no circumstances to be used with5. pivot mountingsNote: See chart on page 37 to check wrenchflats or spanner holes36