12.07.2015 Views

Integrator's Reference Manual for Polycom HDX ... - 1 PC Network Inc

Integrator's Reference Manual for Polycom HDX ... - 1 PC Network Inc

Integrator's Reference Manual for Polycom HDX ... - 1 PC Network Inc

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

System CommandspricallbycallSets or gets the PRI call-by-call value. This command is only applicable if youhave a PRI network interface connected to your system.Syntaxpricallbycall getpricallbycall set {0..31}ParametergetsetDescriptionReturns the current setting.Sets PRI call-by-call when followed by a value from{0..31}.{0..31} Range of call-by-call values.Feedback Examplespricallbycall set 1returnspricallbycall 1CommentsCall-by-call is a number from 0 to 31, which is optionally sent to an upstreamtelephone company switch, if required. For example, specify a value of 6 <strong>for</strong> aT1 PRI network interface module that is directly connected to an ATT 5ESSswitch, which is provisioned with Accunet. You must consult with thetelephone company service provider to determine whether a call-by-call valueis required <strong>for</strong> a particular PRI line. For most cases, the default value of 0 iscorrect. Always use the value 0 when connected to a PBX. A non-zero valueshould not be required in Europe. Values greater than 31 are reserved <strong>for</strong>internal use and must not be used.4 - 177

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!