Integrator's Reference Manual for Polycom HDX ... - 1 PC Network Inc

CStatus MessagesStatus DisplayThe call status can be displayed in a number of ways. The getcallstate(deprecated) command on page 4-100 returns a table listing the status,speed, and dialed number of current calls.To display real-time status on individual B channels (incoming or outgoingcalls), either register the API session with the callstate command onpage 4-30, or start an outbound call with the dial command on page 4-55.These two commands will cause the system to re-direct the B channel statusmessages to the session which has issued one of these two commands. Forexample, if the RS-232 device issues a dial or listen command, then callstatus is directed to the RS-232 port; if a later session on a Telnet port issues adial or listen command, then call status is also directed to that Telnet port.B Channel Status Message ExampleThe following output example is for B channel status messages, where:csRINGINGCONNECTEDBONDINGCOMPLETEIndicates call status for one B channel.Indicates a ring-in or ring-out and is equivalent to a 25% bluesphere on the graphical user interface.Is equivalent to a 50% yellow sphere.Indicates the bonding protocol is operational on the channel andis equivalent to a 75% orange sphere.Is equivalent to a 100% green sphere.C - 1