Integrator's Reference Manual for Polycom HDX ... - 1 PC Network Inc

Integrator’s Reference Manual for Polycom HDX SystemsprichannelSets or gets the PRI channels that will be active for the PRI line. This commandis only applicable if you have a PRI network interface connected to yoursystem.Syntaxprichannel get allprichannel get {1..n}prichannel set allprichannel set {1..n} Parametergetall{1..n}setonoffDescriptionReturns the current setting. Requires a parameter from.Selects all PRI channels and returns all channels andsettings similar to briallenable.Range of available PRI channels. For PRI T1, therange is 1..23. For PRI E1, the range is 1..30.Sets the PRI channels to be active when followed by aparameter from and from .Activates the selected PRI channels.Disables the selected PRI channels.Feedback Examples• prichannel 1 on• prichannel 23 offImportant PRI Channel InformationOutgoing Call. For an outgoing call, the system uses the first active andavailable channel starting with the lowest number from the channel range(1-23 for a PRI T1 and 1-30 for a PRI E1). If an additional channel is needed, thesystem chooses the next incremental number. For example, if channels 1through 7 are inactive, but 8 is active and available, then 8 is the first channelthat can be used by the system to place an outgoing call. If an additionalchannel is needed, the system will use the next available active channel in therange (which could be 9, and so on).Incoming Calls. For incoming calls, the system may use the highest numberedchannel in the range and, if needed, proceed to the next channel number indescending order, depending on the type of third-party equipment attached tothe system. For example, an incoming call arrives on channel 23, then 22, 21,and so on.Dedicated full PRI T1 or E1 Line. All channels should be active for a full T1or E1 line dedicated to your system.4 - 178