AT Command Set - Olitec

6.1.5 AT+CGQMIN Quality of Service Profile (Minimum acceptable)Test commandAT+CGQMIN=?The test command returns values supported as a compound value. If theMT supports several PDP types, the parameter value ranges for each PDPtype are returned on a separate line.Response+CGQMIN: , (list of supported s), (list of supporteds), (list of supported s) , (list of supporteds), (list of supported s) [+CGQMIN: ...]OK/ERROR/+CME ERRORParameterString parameter of Packet Data Protocol typeIPSee write commandSee write commandSee write commandSee write commandSee write commandRead commandAT+CGQMIN?ResponseThe read command returns the current settings for each defined context. Ifno minimum profile was explicitly specified for a context, simply OK will bereturned, but default values will be used for that context.+CGQMIN: , , , , , [+CGQMIN: ...]OK/ERROR/+CME ERRORParameterSee write commandSee write commandSee write commandSee write commandSee write commandSee write commandWrite commandAT+CGQMIN=[[,[,[,[,[,]]]]]]This command allows the TE to specify a minimum acceptable profilewhich is checked by the MT against the negotiated profile returned in theActivate PDP Context Accept message.The set command specifies a profile for the context identified by the (local)context identification parameter, .A special form of the set command, +CGQMIN= causes the minimumacceptable profile for context number to become undefined. Inthis case no check is made against the negotiated profile.AT&F and ATZ will undefine the minimum QoS profiles of every contextwhich is not active or not online.Page 162 of 207