AT Command Set - Olitec

4.24 AT+CLVL Loudspeaker volume levelTest commandAT+CLVL=?Response+CLVL: (list of supported s)OKRead commandAT+CLVL?Response+CLVL: OK/ERROR/+CME ERRORWrite commandAT+CLVL=ResponseOK/ERROR/+CME ERRORParameter Loudspeaker Volume Level (0-4)ReferenceGSM 07.07Note• The write command can only be used in audio mode 2 – 6.• The values of the volume steps are specified with the parameters,... of the AT^SNFO command.• As an alternative to AT+CLVL, you can use AT^SNFO and AT^SNFV.The parameter is identical with used by both commands.• Any change to (or ) takes effect in audio modes 2 to6. That is, when you change < level> (or ) and then selectanother mode with AT^SNFS, the same step will be applied.The only exception is audio mode 1 which is fixed to =4 (or accordingly=4).• (or is stored non-volatile when the ME is powereddown with AT^SMSO or reset with AT+CFUN=1,1.Page 94 of 207