AT Command Set - Olitec

eceived. See also Chapter 4.46."service" Service availability (0-1)."sounder"Sounder activity (0-1). The indicator provides informationabout tones generated in the ME. Thevalue 1 means for example:Incoming call - ME is ringing.Waiting call – ME generates waiting call tone (ifcall waiting is enabled).Outgoing call – ME generates Call Progress tone.Outgoing call – ME generates BUSY tone.The value changes to 0, when the tone stops."message" Unread short message(s) (0-1)."call"Call in progress (0-1). Voice und data calls only.The indicator changes its value as soon as a callhas been established, for example when both interlocutorsare connected or when the call ends."roam" Roaming indicator (0-1)."smsfull"A short message memory storage in the MT hasbecome full (1) or memory locations are available(0); i.e. the range is (0-1).integer type value, in the range stated above for the corresponding.ReferenceGSM 07.07Note• Only the indicators which are registered (see AT+CIND command), will be reportedif CMER is enabled.• After CMER has been switched on, +CIEV URCs for all registered indicatorswith their default value will be presented to the TE.• While the ME is in online data mode, no URC will be displayed. Each +CIEVURC is replaced with a Break (100 ms), and is stored in a buffer. Once the MEgoes into command mode (after +++ was entered), all URCs stored in thebuffer will be output.Exception: For “message” indicator, please note that each incoming short messagewill cause a Break.• See AT+CIND in Chapter 4.19.Page 97 of 207