Instruction Manual - Sierra Instruments

More documents

Recommendations

Info

Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesInstalling your Instrument—Electrical ConnectionsAll electrical connections for your SmartTrak instrument are made on the left (inlet)side panel. See Figure 2-2: SmartTrak Connections below for the location of allconnections. Note that the CAT-5 connector is not an ethernet connector.CAT 5HD DB 15Figure 2-2: SmartTrak connections16
Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesSmartTrak is provided with a high density 15-pin D Connector called an “HD DB-15” located on the side of the enclosure and either one of our optional preassembledcommunications cables or an empty mating connector. Power must besupplied to the HD DB-15 connector. Other features may be accessed there as well.The pin numbers and assignments for the HD DB-15 connector are shown in Figure2-3: HD DB-15 Connector Pin Configuration (on the instrument). Thecorresponding colors of the optional communication cable wires and the functionsof each are listed in Figure 2-4: Wiring Definitions for Optional CommunicationCable. The connections for input power, analog output signal and analog inputsignal (controllers only) are all made at the HD DB-15 connector. There is asecond copy of these 2 figures in Appendix D for your convenience17
Page 1 and 2: Sierra Instruments Instruction Manu
Page 13: Sierra Instruments Instruction Manu
Page 22 and 23: ATP: 1Fiscal Year: 2012STIP for FY
Page 66 and 67:
Sierra Instruments Instruction Manu
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Sierra Instruction Manual SmartTrak
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
show all

Instruction Manual - Sierra Instruments

Create successful ePaper yourself

Delete template?

Save as template?